Question

Can you test a fuse with a cell phone?

Answer 1

You can test a fuse with a cell phone.

A fuse can be tested to see if the fuse is intact using a smartphone's capacitive touchscreen, which acts as a conductor.

By opening a keypad or a calculator app on your smartphone and touching a good fuse to the smartphone screen, the phone should register the touch of the fuse.

If the smartphone screen does not register the touch of the fuse, then the fuse is likely bad.

Although using a smartphone to test a fuse is not always reliable and not recommended for critical applications.

If you can see through the fuse, you can look for signs that the fuse is blown.

If the fuse is blown, the actual metal inside the fuse should be melted into, which stops the flow of electricity through the fuse.

To tell if a fuse is blown and needs replaced, visually check the fuse for a broken wire or a dark spot inside of a clear fuse.

You can also use a multimeter to test the fuse, by checking for continuity.

A beep from your multimeter when checking a fuse using the continuity test means that the fuse is good.

And no beep from the multimeter when checking a fuse using the continuity test means the fuse is blown.

You can also use a test light on the fuse's metal tabs to see if power passes through the fuse.

If the electrical component stops working, then a fuse is often the cause.

You can also test some fuses without pulling them out, using a continuity test with your multimeter.

Simply insert each probe into the open slots on each side of the fuse.

To test fuses with a multimeter, you set the multimeter to the continuity mode, which is symbolized by a sound wave or a diode icon.

You can also use the Resistance/Ohms setting to test a fuse and a good fuse should have very low resistance, ideally near zero ohms (0 Ω) or a continuity beep, indicating a closed circuit, while a blown fuse shows infinite resistance (open circuit or OL).

The exact value varies but is usually less than 0.2 ohms for automotive fuses, as its primary job is to melt, not to impede current during normal operation.