To replace the battery or batteries in the Pride Go Chair.
Remove the battery box.
Turn the pack upside down.
Remove all screws that are holding down the battery box halves together.
Flip the battery box back over so that the handle is up and then remove the lid.
Remove the red (+) positive and the (-) black negative battery leads from each battery.
Remove the batteries.
Then put the new batteries back into the battery box with the battery terminals facing up.
Reconnect the 2 battery leads to the battery terminals and making sure the red goes to the positive and the black goes to the negative terminal.
Replace the lid and then flip the battery box over so the handle is down.
Then replace all screws and tighten them so the battery box is held together.
Then reinstall the battery box back onto the Go Chair.
To take apart a Go Go scooter or other scooter.
Lift the seat off of its post.
Fold seat down, if possible.
Remove the basket and battery pack.
If there is a connector, use it to separate the body into sections.
Finally, lower the tiller and lock it into place.
The speed of a gogo elite traveler scooter is 4 mph and has a range of 12.4 miles per full charge and a weight capacity of 300 lbs.
To charge a Gogo Elite scooter simply plug the charger into the scooters charging port and plug the charger into the house outlet.
Allow the Gogo Elite scooter to charge for around 14 hours or until the charging indicator light turns green which means the battery is fully charged.
There are several reasons your Gogo scooter is not working such as battery being too low, the scooter not being turned on, the scooter is in freewheel mode, the scooter has a throttle trip etc.
Your Go Go Elite Traveler is beeping to indicate something is wrong that needs fixed.
The amount of beeps that your Go Go Traveler is beeping will tell you what it's beeping for.
For example 6 beeps on a Gogo traveler scooter means that you have a throttle trip.
When this occurs and you hear the 3 beeps on your Gogo scooter the throttle lever was pressed while turning on the scooter.
To fix this and stop the 6 beeps on your Gogo scooter Turn the key off.
Remove your hands from the tiller.
Turn the scooter on.
These beeps are not catastrophic; rather, they are simple reminders to ensure the travel mobility scooter maintains its impressive ability to perform.
If your Gogo scooter starts beeping after holding the throttle down for a few seconds it is likely that cruise control is turned on.
Cruise control is a P1 setting and can be turned on and off through display menu.
If Cruise control is on then the scooter will maintain its current speed after you release the throttle.