How do I fix no spark?

0 votes
asked Sep 1, 2022 in Lawn Mowers/Garden Tractors by Justinfartty (1,650 points)
How do I fix no spark?

1 Answer

0 votes
answered Sep 25, 2022 by Medlock12334 (8,940 points)
To fix no spark you have to determine what is causing the no spark.

If on a lawn mower the most common cause of no spark is a bad magneto or bad spark plug or it could be a kill wire to the magneto being worn and coming into contact with the engine or grounding of the lawnmower.

A magneto is responsible for making spark and if it's bad it won't make spark to the engine on the lawnmower or other small engine.

Also a dirty flywheel can be a cause of no spark such as rust on the flywheel which prevents the magnet from working correctly with the magneto.

On a vehicle with no spark the cause can be a bad ignition coil, bad ignition module, bad spark plugs, bad timing etc.

To adjust and set the timing on a Briggs and Stratton engine you have to remove the bottom oil pan and get access to the crankshaft and gears.

Then you align the timing marks on the gears inside the engine so that they match up.

Both the intake and exhaust valves should be closed when the timing marks are lined up on the engines gears.

To adjust the magneto on a Briggs and Stratton engine use a feeler gauge and loosen up the bolts holding the magneto.

Then slowly move the magneto forward or backward while you have the feeler gauge in between the magneto and flywheel until you get the gap set correctly.

The gap for the Briggs and Stratton magneto and flywheel are in the ranges of . 006 - . 010"

To test a magneto you can use a multimeter to check the ohms readings of the magneto tell if it's working or not.

To test the magneto with a multimeter set your multimeter to Ohms (Ω), and make sure the Ohm range is set to 40k without any auto-ranging.

Next place your multimeter probes at the magneto copper winding and the metal clip under the rubber casing.

Any value below or above the 3k to 15k range implies that the magneto coil is faulty.

A magneto cannot be repaired and can only be replaced.

A magneto is basically a coil with copper or aluminum wire wound inside it and cased in plastic etc to cover the wire.

There's no way to repair the magneto as it would require dismantling the magneto and rewinding it.

So you would need to replace the bad magneto with a new one if it has gone bad.

You can clean your flywheel with brake cleaner and even a wire brush or sand paper.

Simply use some sand paper or a wire brush to clean off the rust on the flywheel and then spray it with brake cleaner to wipe away any leftover rust.

To test a flywheel with a magnet place a piece of metal such as a screwdriver in front of the magnet to check if the magnet is still strong or weak.

If the magnet seems weak and does not pull the screwdriver quickly towards it then the magnet is likely bad but if the magnet pulls the screwdriver to it quickly and holds it good then the magnet is good on the flywheel.

To clean the flywheel on your lawnmower remove the shroud over the flywheel.

Then use some sandpaper and gently sand the rust off the flywheel.

Don't be too aggressive with the sandpaper but gently sand the flywheel until it's clean of rust.

You can also use a wire brush on a drill or a hand wire brush but go slowly.

You can then also spray the flywheel with some brake cleaner to help clean the rust off.

A flywheel magnet can lose magnetism although you can re magnetize the flywheel magnet by using another strong magnet and passing it in front of the flywheel magnet.

You re magnetize a magnet by bringing it into contact with a strong magnet.

So, if you have a weakened magnet, you must carefully bring it to contact with a strong neodymium magnet.

This will make your weakened magnet regain its magnetic force. That was it.

A flywheel magneto is a type of ignition coil that produces electricity to create spark by way of magnetism.

As the flywheel magnet on the flywheel spins across the magneto is produces voltage which in turn creates spark to ignite the fuel to start the engine.

A magneto creates spark by way of the magnet on the flywheel.

The magnet on the flywheel spins and passes in front of the magneto which then creates the electricity.

And as the magnet spins (or the magnet rotor is turned), it generates a strong magnetic force that is “held back” by a primary coil.

Then the moment the contact points open, a rapid magnetic flow generates a high voltage in the secondary coil, which ignites the spark plug, thus firing the engine.

Whereas an electromagnet uses electricity passing through a coil to produce a magnet, a magneto uses a magnetic field in the vicinity of a coil, called the armature, to produce an electric current.

A magneto is an electrical generator that uses permanent magnets to produce periodic pulses of alternating current.

Unlike a dynamo, a magneto does not contain a commutator to produce direct current.

The magneto is a self-contained generator of high voltage that provides ignition to an engine through spark plugs.

A magnet—hence magneto—spins in close proximity to a coil of wire.

As the magnet spins (or the magnet rotor is turned), it generates a strong magnetic force that is “held back” by a primary coil.

An ignition magneto, or high-tension magneto, is a magneto that provides current for the ignition system of a spark-ignition engine, such as a petrol engine.

It produces pulses of high voltage for the spark plugs.

The older term tension means voltage.

A magneto is an electrical generator that uses permanent magnets to produce periodic pulses of alternating current.

Unlike a dynamo, a magneto does not contain a commutator to produce direct current.

The beauty of a magneto is its simplicity.

When one fails, it's not dramatic, and will not result in a catastrophic engine failure unless both mags shoot craps at the same time.

If that happens, the engine will stop running or might run rough (missing on one or more cylinders).

Because it requires no battery or other source of electrical energy, the magneto is a compact and reliable self-contained ignition system, which is why it remains in use in many general aviation applications.

98,443 questions

94,708 answers

1,269 comments

6,992,350 users

...